4l60e shift kit installed wont go into gear

5.2.3 Route the engine group and tail section through the hole. 5.2.2 Drill a 1-5/8' hole for the firewall grommet near the computer for the engine group and tail section to pass through. 5.2.1 Position the computer and sensors in their intend locations. Note: Make no wire connections or permanent mounting of any kind at this time. ДҐ.2 ROUGH INSTALLATION CAUTION: DISCONNECT THE POWER FROM YOUR VEHICLE BY REMOVING THE NEGATIVE BATTERY CABLE FROM THE BATTERY. Delco# 214-396 Brake Switch.GM# 25524845 Gear Indicator Switch.GM# 15705308 or Intake Air Temperature.GM# 12110319 Delco #D2286A Ignition Module.Delco# D-1986-A MAP Sensor. This system has four rectangular connectors at (The computer looks for signals from these controls and does not care if the actual devices are installed.) 4.2 YOU SHOULD GET TO KNOW THE PARTICULAR ENGINE YOU ARE USING: NOTE: The 94 & 95 LT1 engine has two oxygen sensors, one on the right side and one on the left side of the engine. To keep the check engine light from coming on you will need to plug in a canister purge solenoid and air pump relay to the wires in the dash section. Electric drill 1 5/8' Hole saw (for the rubber grommet in the firewall) 4.0 PRE-INSTALLATION AND HARNESS ROUTING GUIDELINES The installation of your harness kit will consist of two p Wire stripper Continuity tester CAUTION: DO NOT USE A TEST LIGHT TO TEST THE COMPUTER OR SENSOR WIRING OR YOU WILL DAMAGE THE COMPUTER. 10 Table 6.3 Tail Section Connections.ДЈ.0 TOOLS NEEDED In addition to your regular tools, you will need, at least, the following: Crimping tool NOTE: USE A QUALITY TOOL TO AVOID OVER-CRIMPING. LIST OF TABLES Table 4.1 Compatible Parts. 1 4.0 PRE-INSTALLATION AND HARNESS ROUTING GUIDELINES. Or, better yet, send us a fax at (817) 244-4024 or e-mail us at We sincerely appreciate your business. If you have found any errors or omissions, or if you simply have comments or suggestions concerning these instructions, please write us at the address on the cover and let us know about them. We have attempted to provide you with as accurate instructions as possible, and are always concerned about corrections or improvements that can be made.

4l60e shift kit installed wont go into gear